How to use corrugated ceramic saw blade correctly?

1. Keep away from fire and humid environment.

2. Select the matching saw blade according to the design requirements of the equipment.

3. The equipped equipment should be equipped with safety protection devices, such as: protective cover, power failure brake, overload protection, etc.

4. There are professional operators to install and use, and wear labor clothes, wear protective glasses, ear muffs, etc., and take protective measures.

5. The operator must not wear gloves, long hair should be placed in the work cap, and pay attention to the tie and cuffs to prevent danger.

6. During the cutting process, you must pay attention to the position of the piece and control the speed of the cutting product, and do self-protection measures.

7. To prevent the broken friction of the product cut by the cutting knife in the frame, it must be washed with water, and it is strictly prohibited to clean it directly by hand.

8. After cutting, please wipe the anti-rust oil in time to prevent rust

Tile saw blades can be used wet and dry, continuous corrugated saw blades are usually used to cut tiles / ceramics / ceramics

Second, the installation requirements of narrow turbine edge dry cutting blades:

1. The equipment is in good condition, the main shaft is not deformed, and the diameter is not fixed, and the vibration is fixed.

2. Check whether the saw blade is damaged, whether the tooth shape is complete, whether the saw board is flat and clean, and whether there are other abnormal phenomena to ensure safe use.

3. When assembling, make sure that the arrow direction of the saw blade is consistent with the rotation direction of the main shaft of the equipment.

4. Wet use corrugated tile saw blade installation When keeping the axis, the chuck and the flange are clean, the inner diameter of the flange is the same as the inner diameter of the saw blade, ensure that the flange and the saw blade are tightly combined, install the positioning pin, and tighten the nut. The size of the flange should be appropriate, the outer diameter should not be less than 1/3 of the diameter of the saw blade

5.Before starting the equipment, ensure the safety, there is a single return person to operate the equipment, jog idle, check whether the equipment is turned correctly, whether there is vibration, after the saw blade is installed, first idle for a few minutes, no slip, swing or jump normal work

Requirements

1.When working, the workpiece should be fixed, and the profile positioning should be consistent with the direction of the knife to avoid abnormal cutting.Do not apply side pressure or curved cutting.The feed should be stable to avoid the blade from impacting the workpiece, which may cause damage to the saw blade, or The workpiece flew out and an accident occurred.

2. When working, if you find abnormal sound and vibration, rough cutting surface, or odor, you must immediately terminate the operation, check in time, and eliminate the fault to avoid accidents.

3. When starting cutting and stopping cutting, do not feed too fast to avoid broken teeth and damage.

4. If cutting aluminum alloy or other metals, special cooling lubricant should be used to prevent the saw blade from overheating, producing paste teeth, and other damages, which affect the cutting quality.

5. The chip chute and slag suction device of the equipment ensure unimpeded flow to prevent slag accumulation and affect production and safety.

6. When dry cutting, please do not cut continuously for a long time, so as not to affect the service life and cutting effect of the saw blade; wet blade cutting should be cut with water to prevent leakage

For ceramic saw blade knowledge, just share this first. If you have any help, please feel free to contact us.