Installation and technical requirements Shabu round

Shabu roundWhen the grinder to install, requiring contact with the wheel flange surface clean and smooth, both sides caught in the wheel flange shape, size must be the same. When fastening grinding wheel, requiring elastic medium, too loose, too tight or wheel flange in contact with the uneven surface is an important factor leading to damage to the wheel. And only allows the use of special wrench reinforced by hand, prohibit the use of supplementary fixtures (such as a long wrench) and tap wrench to prevent artificial abrasive damage.
Shabu wheel spindle shall meet the technical requirements, shaft diameter is too small, install a different heart wheel, causing the wheel blast beat even when in use.
When using the wheel, and to raise the wheel guard, in order to ensure safe use.
Wheel installed, should idle for 1-2 minutes, then official use.
Shabu round use rate should not exceed the specified operating speed of the trademark when using pneumatic tools, grinding, especially when multiple machines using the same gas source, to control the air pressure to prevent the pressure is too large, resulting in more than the maximum operating speed to wheel rupture hurt.
When you use the wheel to slowly feed, excessive force, easy to send the wheel and crashed stall stuck wheel phenomenon. If there Shabu round stuck to immediately lift the wheel to avoid wheel burned out or broken card.