What are the possible problems and corresponding reasons when using diamond multi-wire cutting?
What are the possible problems and corresponding reasons when using diamond multi-wire cutting?
1. Why the slab appear various thickness?
Main reason:
(1) Down feed is too fast.
(2) Tension force is not enough.
(3) lubber belt broke or worn-out.
(4) Part of the diamond wire are in low performances.
2. Why the slab surface appear scratches?
Main reason:
(1) Tension force is not enough.
(2) The rubber belt broke off from the guide wheel trough.
(3) Tiny rocks fall into the cutting seams.
(4) The diamonds on the wire are in low situations.
3. Why there is a big difference in cutting diamond multi-wire saw (controlled within 2cm)?
Main reason:
(1) Tension force on each wheel are different.
(2) Each diamond wire’s performance are different.
(3) Down feed is too fast.
4. Why the cutting seam become wide?
(1)The rubber belt is seriously worn-out.
(2)The diamond wire trembling while cutting.
